.22-250 calibre review.
Most of us are happy to shoot .222 Remington cartridges at mid-ranges; however, sometimes a cartridge with more velocity can be desirable.

The .22-250 is the best of the .22 centrefires in terms of versatility and ballistics. The .220 Swift may be regarded as the king as far as velocity goes, but the .22-250 can be loaded to be as good if not better and is more flexible in reloading. The .22-250 is the choice of shooters who want velocity combined with accuracy and performance at extreme ranges.

Calibre in context
The .22-250 started life as a Wildcat cartridge and has its origins as far back as 1915. Its parent cartridge was the mild .250 Savage cartridge, designed for deer use.

However, after much modification it evolved into a necked down version, which became the .22 calibre and was capable of pushing a 50-grain bullet at more than 3,750fps.

Despite a good following among many enlightened shooters it was not until 1965 when Remington, which knew a good thing when it saw it, legitimised the Wildcat into a factory round. When any Wildcat cartridge was adopted by a firearms manufacturer its popularity soared.

Factory ammunition and cheap brass for reloading encouraged shooters to use the .22-250 over the .222 Remington. The advantages were obvious – at least a 475 to 650fps difference was evident from good handloads and though more powder was burnt less efficiently than the smaller cases, accuracy was not impaired.

Performing to please
Coupled with a scope of high magnification and loaded with carefully prepared handloads, the .22-250 was taking corvids and foxes at 400 yards with great certainty. Not only was the extra velocity an advantage, but the ability to launch heavier 55-grain bullets at higher velocities than almost any other cartridge offered the varmint hunter major advantages.

As with most benefits there are pitfalls – obviously more powder is necessary to achieve these inflated ballistics and that causes more recoil, barrel throat erosion and noise and muzzle flash. Even in a heavier- barrelled rifle the target will disappear from view under recoil unless you have a muzzle brake. Noise and muzzle flash are only a problem in certain situations.

In unpopulated areas were foxes or varmints are encountered during daylight it shouldn’t cause any problems. However, start lamping foxes in an urban setting and your presence may not be appreciated.

The muzzle flash also obscures your view of the target and destroys night vision – sound moderators really come into their own here. Despite these detractions, the .22-250 certainly remains one of the most popular tools among fox shooters in this country. Its ability to connect with small targets at long ranges makes for challenging sport and the manner in which those 40- or 55-grain bullets expand is very reassuring.

I like the versatility of the round – you can load it from reduced velocity through to .222 Remington velocity levels and up to Swift velocities, while retaining its accuracy.

Locking on to loads
I will start with the 40-grain bullet heads. These are ballistically brilliant, however, bullets with thick jackets must be used rather than those with thin jackets, such as for use in .22 Hornet rifles or the Hornady SX range.

If you don’t, the bullets will come apart as the centrifugal force of the rifling imparts its spin.

The Berger 40-grain MEF, Nosler Ballistic Tip and Hornady V-Max are good, and coupled with 36.25 grains of Hodgdon Benchmark powder, maximum load will yield a 4,021fps velocity from a 24in barrel. That is fast by any standards and it is why that little 40-grain bullet shoots as flat as a pancake and is highly expansive when it reaches its target.

There are disadvantages – being small, it will lose its energy quicker than the larger bullets and is therefore more susceptible to wind deflection – but at realistic ranges this can be compensated for, with practice.

Bullets in the 50-grain and 52-grain range are more like the ideal varminting weight as 35.75 grains of Alliant RL15 generates 3,671fps and 3,611fps respectably. This load makes an excellent long-range foxing round as well as being more than capable for roe in Scotland.

If you prefer to use a heavier bullet, especially for extended ranges or for roe, then I use the 55-grain bullets with a powder weight of 38.0 grains of Hodgdon Varget or Vit N140, which achieves a healthy 3,600fps with a 55-grain bullet head.

This weight is about ideal in a .22-250 round as it gives predictable accuracy, good wind-bucking properties and a reliable performance on varmints, foxes or roe in Scotland. As with all bullet choices, be sure to match the bullet type, ie. thick or thin jacket, hollow or soft point, to the game you are after, otherwise the heavy bullets will not expand predictably on small varmints such as crows or rabbits, while 40-grain or 50-grain V-Max.

TNT or similar may expand too quickly and cause surface wounds with little penetration, which is definitely not what you want on foxes.

A 52-grain Hornady A-Max bullet travelling at 3,700fps when zeroed 0.5in high at 100 yards drops 0.9in at 200 yards, 3.1in at 250 yards and 6.2in at 300 yards, thus allowing for minimum sight correction.

Getting Heavy
Of course, there are heavier bullets available in the .22 centrefire range, such as 60-, 63- or 70-grain bullet heads.

For example, 38.0 grains of H414 gives 3,494fps with the 60-grain head and 37.75 grains gives 3,417fps with the 63-grain bullet.

However, because most standard .22-250 factory rifles have a barrel rifling twist rate of 1:14, they are designed to stabilise the lighter bullet weights better.

With this in mind, you may find that the heavier bullet weights will deliver poor accuracy, as the bullets will not stabilise adequately. I like the 52- or 55-grain, which gives the best of both worlds for foxes or roe in Scotland.

Shooting a .22-250 does not just mean running at full throttle, sometimes a reduced load becomes useful for those quieter moments in life when the sheer power of the .22-250 is not required. A load of 18 grains of H4198 with a 50-grain Sierra Blitz King bullet, which gives a healthy 2,388fps, is great for around the farm with a sound moderator.

Do not think you have to reload to achieve these ballistics – commercial manufacturers offer the shooter a comprehensive range of loads that span all the available bullet weights. I tested a broad cross-section from most manufacturers. Factory ammunition these days is very good and the test ammunition shot well in a Tikka T3 and Howa varmint rifle.

Future perfect?
Despite its age, the .22-250 continues to offer excellent performance and inherent accuracy to today’s shooters. It is a very versatile and flexible cartridge, offering a range of bullet weights and velocity spectrums.

With a good range of factory ammunition and reloading components, this calibre will be around for many years to come. But will the latest developments with the new .204 calibre projectiles see these new hyper-velocity cartridges eroding the .22-250 status? I am testing .204 calibres as you read this.

Read more gun reviews!

This article is from

Shooting Times – Shooting Times is the UK’s leading weekly shooting magazine, selling over 1.1million copies each year. Since 1882 it has brought a weekly fix of shooting news, sport and countryside action to its hugely loyal readership. Shooting Times is the clear first choice for shooting sportsmen, with editorial covering all disciplines including gameshooting, rough shooting, pigeon shooting, wildfowling and deer stalking. Like us on Facebook  |  Follow us on Twitter

Subscribe to Shooting Times in print » | Read the digital edition »

  • mark rosenbaum

    for reloading try the adi reloading book from the ADI website. The winchester supreme in 50grn or 55grn ballistic tips are expensive but great factory loads even the hornady 50grn are good. glenn try using a 50grn ballistic tip and seat the bullet the entire polimer tip length longer than standard factory loads, i only have a 20″barel and can shoot a 0.5″ group with 5 shots at 300m i use adi BM2 powder and nickel cases with benchrest federal gold primers or better! Always seat the projectile to be just of touching the rifeling!

  • jay

    22/250 is a superb foxing caliber. 50,55 or even 60 grain bullets if you have the right twist is
    moving abit in the 22/250 !

    great flat shooting round and under lamp at night
    really shows its worth.

    i use 50 grain blizkings in my 1 in 12 twist
    with varget or imr 4007 ssc

  • Ian

    James I use to have a 22-250 a savage ss varmeter if its any help Iused winchester shells,nosler gold medal primers 36.5gns n140 and v max 55gn for under .5 in groups or speer target hpbt 52gns with 36gns n140 for clover leaf groups.mostly used in the lighter barrels seem to be cci200 primers 37gns n140 and speer 52gn hp [VARMET TYPE] this is genuine imfore mate goodluck

  • ryan jurgess

    what is some reloading data for the berger 70 graing target bullets for the 22-250 model 12 savage using imr 4350 powder and winchester large rifle primers. and how much would the bullet drop at distances out to 500 yrds

  • Tim

    Hello, wondering if you can help me on the solution of the best .22-250 in sako? Iam a gamekeeper so synthetic stock is best. I do alot of foxing so could do with the most accurate rifle as i do long range shots with in limit of the gun and do alot of shooting. The thing is i here about the length of the rifle and how many twist you need in inside the barrel this is where i could do with your help as do not really understand.
    many thanks
    Please dont publish

  • james sheen

    hi there, i was woundering if you could tell me a maximum recomended powder load for a 22.250 useing 55grain softnose bullets with vihtavuori n140 powder. i used to use hogoden powder but was very smokey rifle had bad obsturation, i was advised sometime ago to use n140 and load 5% below and 15% above recomended maximum load, after asking the shop where i bought the n140 from,he told me it was 36.5 i then asked another shop and he said it was 32.8 – 34.8. after reading your review of the 22.250 you recomended 38grain is this a max load with soft nosed bullets, as iam not to happy to continue with all the different load sizes i have been giving,and could you also tell me if the load would change when going from a 55grain to a 50 grain bullet head. thank you very much for your time and help.

  • Glenn Koch

    I have a new 22/250 Remingtin in a Weatherby SVM with a 26 inch tube and a 1 in 14 twist. I also have a Leupold 8.5X25-50MM Long Range with AO mounted on the rifle. When developing a load I am using a bench rest rifle holder. My problem here is that I can not get the gun to tighten up its groups. Have tried Bergers 52gr with 41gr of H380, Speer 55gr with 39gr H4350 and on and on with different powders and bullet weights. No mater what bullet or powder I use the groups just do not seem to tighten up. Any suggestions? Scope has been torqued down, all screws tightened.

    Cheers & Tighter Groups: Eaglesnester B.C. Canada

  • wayne

    hi ive just recentely bought my self a tikka t3 lite stainless in 22.250 calibre and i know i am legally aloud to shoot muntjacks in england but why is it in scotland you can use this exact same calibre for roe deer but not in england. do you know is there any plans to change the laws in the near coming future to allow this calibre to be used on roe deer in england any time soon can you shed any light on this subject many thanks wayne