A: Personally, I don’t think that most of us shoot well enough to get any real benefit from choke. Consequently, I would always go for fixed chokes and ones that were very open. However, if you become a very good shot, then screw-in chokes may help.
The first wave of screw-in chokes appeared in the late 1970s with the Winchester 101 series of guns. Since then, multi-chokes have been very popular, both as factory standard and as custom attachments from specialist makers.
Multi-chokes offer tremendous versatility without the need to own a number of shotguns, but they need to be looked after if they are to remain trouble-free. Always pay close attention to the manufacturer’s instructions for the maintenance of multi- chokes. Multi-chokes sit in a section of the muzzle that has been specially machined to receive them. It is vitally important to ensure that they are screwed fully home so that there is no gap between the inside of the barrel and the base of the choke section. If even the tiniest gap exists, there is a very real possibility that serious damage will occur to the gun.
Research undertaken by BASC at the Royal Military College of Science, Shrivenham has shown that even if a choke tube is not fully home by the slightest margin, as little as a single turn, then damage can occur. This is known as “choke pick-up”. As the first pellets of the shot charge hit the gap, some are forced between the choke tube and the barrel wall, causing distortion and increasing the obstruction. As more pellets hit, the choke distorts further and is eventually blown out of the barrel, damaging the muzzles. It is also a hazard to others as it leaves the barrel.
Edward Watson: Now the season is over, it is so important to keep shooting. Most of you will break some…
When you’re out in the field or the clay ground which chokes for gameshooting and clayshooting will give you the…
As a general principle, multi-chokes should have their threaded sections very lightly greased with something similar to Vaseline before they are screwed home. Beware of over-tightening, and if you are unfortunate enough to get a choke stuck, do not force it but take it to a gunsmith for “surgical” removal.
Check that your chokes are screwed home fully before use and repeat this check after and periodically during use. Chokes should be cleaned occasionally by immersion in petrol or a similar solvent. Pay particular attention to the threads and make sure that foreign bodies such as grit are removed before installing the chokes again. Always discard a damaged choke tube. BH
While Defra has now announced that GL43 will be issued in the coming weeks, avian influenza risk levels are preventing the renewal of GL45
Shotgun and firearms licensing laws are in the spotlight after a Luton teenager murdered his family with an illegally purchased shotgun.
