Home / Yildiz Eleganta A3TM magnum shotgun review

Yildiz Eleganta A3TM magnum shotgun review

Yildiz Eleganta A3TM magnum shotgun review: The Yildiz A3TM shotgun is simple and uncluttered - a side-by-side that is well-suited to the foreshore.

Yildiz Eleganta A3TM magnum shotgun review
ShootingUK
ShootingUK 13 September 2011

Yildiz Eleganta A3TM magnum shotgun review.
A couple of years ago I reported on the Yildiz Eleganta 12-bore 3in magnum that was available as a wildfowling gun.

My conclusion at that time was that it was really a worthy multi-purpose gun rather than a dedicated wildfowling piece.

I envisaged its role covering wildfowling, pigeon shooting and also as a capable side-by-side clay buster.

However, the maker has listened to feedback from, among others, the UK importer and now produced much more of a wildfowling version, the non-ejector 3.1⁄2in magnum A3-T-M variant.

There is an option of an ejector gun but to me a non-ejector makes sense when out on the salt marsh, that truly wild and lonely place under a big sky, an unforgiving environment where unnecessary complexity can prove a nuisance.

As for the fore-end, it is both deep and straight-sided, which is an advantage when holding on to a gun operating under a smart bit of recoil.

The reasonably large and deeply cut chequering also comes into play when a good grip is needed and, after all, this is what it was designed for ? to enhance one?s grip.

The walnut is oil finished, which is what one expects from this maker, and the stock is fitted with a slim, but what turned out on test to be an effective, rubber butt pad.

The grade of walnut on this gun was not as fancy as some Yildiz guns I have seen, but eminently suitable for its intended role.

Both stock and fore-end showed good straight and tight grain, indicating plenty of strength.

SUITABLE CHOKE
An important factor with all aspects of shotgun sport is a suitable degree of choke for the job in hand.

Barrel bore sizes do vary and, as these are relative to the choke constriction, I tend to gauge multichokes against the barrel they will be used in, especially where steel shot is likely to be used.

This gun is provided with the, by now, normal complement of five choke tubes. The barrel bores measured .724in, a little on the tight side for 12-bore but often a better bet when using fibre wads.

The choke tubes provided measured full, three quarters, a rather tight half, quarter and the last was exactly cylinder bored.

Quite good results for an economically priced gun and for testing I chose full choke to use with lead and the tight half for steel.

ACTION STATION
Externally this wildfowling gun appears little different to its predecessor.

Related Articles


Subscribe to Shooting Times & Country
Subscribe to Shooting Times & Country